Decorating houses with siding is common. This is a good type of cladding that allows for insulation.
Many companies, offer deals in installing a cheapest siding, but it’s not that cheap every time. In this article, we provide step by step instructions on how to do this. You can do this completely yourself without resorting to outside help, which will reduce the cost of the entire structure.
It is necessary to buy a start strip that is the height of the wall from which you will start fastening. You will need an outside corner 3 m long. Do not forget about waste when calculating; If you are doing insulation, you will need mushrooms for the mats, which must be attached to at least five elements.
Need A Target Area
All elements are attached to the frame, which consists of a profile or wooden slats. If you chose the second variant, then you should bring the element to the workplace in advance. It should be treated that will prevent the appearance of fungus and extend the life of all structures. A tool should be prepared for work. So you cannot get distracted and do everything with high quality.
To finish the house with siding, you will need a jig. Otherwise, the design of the materials will be disrupted and everything will not be in the right shape. To shorten the time to start laying, the most suitable is the level of hydraulics, which can be purchased from retailers or made by yourself. A quick fix will help make a screwdriver, and it’s best to use a hole punch to drill holes in the hay. The level should be hit with the help of a nylon thread; You need a sharp knife.
The design must have the correct shape and hold on to it. All markups should be done very correctly, otherwise everything will be misaligned and it will be quite difficult to fix.
First of all, we need to correctly determine the degree of installation start. To do this, it is good to apply a hydraulic level. With its help, we can correctly create the bond line. We find the first installation point and then transfer it to other walls using a level.
Now we cut off the line and connect the dots. To do this, we use thread and make a line; after that, we remove everything superfluous from the surface of the house, it can be shutters, grilles, etc. Now we measure along the lower contour of the house and cut the beam to the desired size. Then we hit along the line drawn. We use simple screws to attach it to a wooden surface. If the house is made of bricks, then we will use a dowel or anchor.
